Assignment Five: Color Selector Solution




Previously, I had given a suggested wiring here, but there was no project proposal. This time I am expecting you to think critically about where each component should be connected to utilize the modules in the MSP430 that are needed. There is a lot of wiring here, so _do things in stages and test as you add things to your board!_ This is _critial_ for the project.


You are to submit to me a paper document that possibly has the following headings:

* Introduction

* What project are you doing?

* Components and Modules

* What components will you use?

* How are those components laid out on the breadboard?

* To which pins are they connected?

* Which MSP430 functionality will you use?

* What will those microcontroller modules be doing?

* Schematic Draft

* Visual aids are good!

* Pseudocode

* How will your code be organized?

* Will you have multiple files?

* Multiple functions?


For this assignment, you are to create a color selector using the RGB LED, button, potentiometer and 7-segment display. The behavior should be as follows:

1. On start up, green and blue should be off and the red color should be “selected”.

– the intensity of the red element is set using the potentiometer and

– the value of that intensity should be shown on the 7-segment display (`_r00` – `_rFF`).

– _Note that this means you have to change a value from the range `0` – `1023` to the range `0` – `255`._

1. Pressing the onboard switch selects the next color: green or blue (it doesn’t really matter which).

1. The intensity of the red element is _left at what it was set when the switch was pressed_.

1. Now the next color can be set and the value of the intensity shown on the display (`_g00` – `_gFF`) or (`_b00` – `_bFF`).

– for green, you can use a lowercase `g` (a `9` with the bottom segment turned on)

1. Repeat for the _next_ color.

1. Pressing the switch a third time should cycle back to setting the red color.

1. Periodically, the microcontroller should output to the host (using `cio_printf()`) the name of the current color as determined from a large lookup array, which will be given to you.

This means, in software we are utilizing:

1. All 3 PWM channels (T0.1, T1.1, T1.2)

1. A timer interrupt for the display

– _Note that this means one of the timers is doing both PWM and an interrupt!_

1. A button interrupt

1. The ADC10 module for analog input

– a code file `dtc.c` is provided that implements an `initialize_dtc()` function, use this to work with the potentiometer!

1. A single UART pin (P1.2, UART TXD) that allows us to print to the host (UART RXD will not be used and must be reset after the call to `serial_init()`)

– _Remember that you cannot connect this pin to anything or it will interfere with the UART communication!_

That’s it! Good luck and have fun!

error: Content is protected !!